Worklife - Survey Work at a Mall - More time would have been nice!

avatar

Good day everyone! Zak here from a very hot and sunny Cape Town! I was sent recently to do a survey on a mall's AC... all of it. Over 50 stores, both a long line of shops with split units as well as a Chilled Water system.

It was a lot of work and there are a lot of equipment installed in this mall.

It was a bit funny when I found the sign above: DO NOT SWITCH ON, YOU WILL DYE.

What they fail to mention is which Colour! 🤣🤣🤣🤣

This is down in the Chiller plant. Both Condenser Pumps and Chilled Water pumps are in view here. Quite a bit of work needs to get done here...

All of the water cooled units look like this. Drainpans rusted and a lot of them not flowing well. You can bet that the coils in here have quite a lot of corrosion on them as well!


The view is nice though! On the roof you look directly into Table Mountain. On the left the Cooling Towers still look good. We installed them not too long ago and their condition is still great.

Again, inside a unit. Rusted pulleys and dirty coils.


Some of the DX units are also starting to look worse for wear. Not all of them, but I can bet you that the above unit does not work well!


As much as possible, you want your Chilled Water piping insulated and vapour sealed. Leaving this open like this exposes hundred of meters of piping to vapour sweat and ultimately, corrosion!


Opening up the insulation around the mall revealed a lot of the above. Rusted piping.

It seems that there had been a leaking pipe at some stage and that it had filled up the insulation all over the place, causing corrosion.

I took over 500 photos of this survey and then everything needed to be captured into data. Over 70 tabs on a spreadsheet with engineering calculations.

The suggestion is going to be to replace the old Chilled Water units and all the Split refrigerant units with water cooled Hydronic Cassettes.

We shall see if we get the job! Here's hoping!

Thank you for reading!

Cheers!
@zakludick

Hive South Africa



0
0
0.000
14 comments
avatar

Equipment not installed correctly from the start always leads to complications later on. Never cut costs with initial project it gives longer lifetime in most cases, too many cut corners to regret it a couple of years down the line, normally directly after warranty ends.

!LOLZ
!PIZZA Hope you get the contract after all that work!

0
0
0.000
avatar

Looks like a shocker that needs replacing and the landlords have no choice, but to act before it causes any damage through leaks. Lets hope you guys get the contract for this.

0
0
0.000
avatar

Indeed! It could be a lucrative project to work on, but with myself locked in the docks i do not know who is going to run this project...

0
0
0.000
avatar

Looks like it could be expensive.
!PIZZA
!ALIVE
!LOL
!LUV
!PGM

0
0
0.000
avatar

@zakludick! You Are Alive so I just staked 0.1 $ALIVE to your account on behalf of @ new.things. (4/10)

The tip has been paid for by the We Are Alive Tribe through the earnings on @alive.chat, feel free to swing by our daily chat any time you want, plus you can win Hive Power (2x 50 HP) and Alive Power (2x 500 AP) delegations (4 weeks), and Ecency Points (4x 50 EP), in our chat every day.

0
0
0.000
avatar

Sent 0.1 PGM - 0.1 LVL- 1 STARBITS - 0.05 DEC - 1 SBT - 0.1 THG - 0.000001 SQM - 0.1 BUDS - 0.01 WOO - 0.005 SCRAP - 0.001 INK tokens

remaining commands 0

BUY AND STAKE THE PGM TO SEND A LOT OF TOKENS!

The tokens that the command sends are: 0.1 PGM-0.1 LVL-0.1 THGAMING-0.05 DEC-15 SBT-1 STARBITS-[0.00000001 BTC (SWAP.BTC) only if you have 2500 PGM in stake or more ]

5000 PGM IN STAKE = 2x rewards!

image.png
Discord image.png

Support the curation account @ pgm-curator with a delegation 10 HP - 50 HP - 100 HP - 500 HP - 1000 HP

Get potential votes from @ pgm-curator by paying in PGM, here is a guide

I'm a bot, if you want a hand ask @ zottone444


0
0
0.000
avatar

The signage is so bad I have to wonder if someone did it as a joke!

0
0
0.000